s1_mixer_iso_600pxsonifex04032010
Sonifex S1

The S1 has a multitude of output connectivity: one balanced stereo XLR PGM output, two balanced stereo AUX outputs on a 9-way D-type socket, a mono clean feed output on balanced XLR (for use with a telephone hybrid), a stereo cleanfeed output on stereo balanced XLRs (for use with an ISDN/IP codec) and monitor outputs for presenter headphones, guest headphones and loudspeakers. Additional outputs are provided for talkback on a 9-way D-type socket and metering using a 15-way D-type socket....

 

!
!

The S1 mixer is highly configurable and has numerous options allowing the mixer configuration to be tailored to your requirements. Using the freely available Sonifex SCi software, every parameter of the mixer can be set up with ease.

 

   

 

Technical Specification For S1

Input / Output Impedances

 
Mic Input: > 1k5Ω electronically balanced
Mono Line Input: > 20kΩ electronically balanced
Stereo Line Input: > 20kΩ electronically balanced
PGM Output: < 50Ω electronically balanced
Monitor Outputs: < 75Ω unbalanced
AES Input/Output: 110Ω
S/PDIF Input/Output: 75Ω
BNC Wordclock Input: 50Ω
   

Input / Output Gain Range

Mic Input: Preset pot +21dB to +64dB ref -50dBu, TRIM pot ± 12dB
Mono Line Input: Switch 0dB to +10dB ref 0dBu, TRIM pot ± 12dB
Stereo Line Input: Switch 0dB to +10dB ref 0dBu, TRIM pot ± 12dB
Telco Input: Switch 0dB to +10dB ref 0dBu,
TRIM pot ± 12dB
Stereo Cleanfeed Input: Switch 0dB to +10dB ref 0dBu, TRIM pot ± 12dB
Digital Input: 0dBFS = +18dBu on input; TRIM pot ± 12dB allowing 0dBu to +24dBu
Digital Output: 0dBFS = +18dBu
   

Frequency Response

Mic Input: 40Hz to 20kHz –1dB, +0dB
Line Inputs: 20Hz to 20kHz –0.5dB, +0dB
RCA Inputs: 20Hz to 20kHz –0.5dB, +0dB
   

Noise (20Hz to 20kHz)

Mic Input E.I.N.: -130dB with 150Ω source.
Stereo Inputs -92dBu ref 0dB (fader down, no routing)
-91dBu (fader down, one channel routed)
-86 dBu (unity gain, one channel routed)
-83 dBu (unity gain, two channels routed)
   

Distortion

Total Harmonic Distortion: 0.015% at 1kHz, 0dBu 0.015% at 10kHz, 0dBu
   

Crosstalk

Inter-Channel: < -80dBu typically
   

Equalisation

LF: Shelving at 100Hz ± 7dB
HF: Shelving at 6.5kHz ± 7dB
   

Range

Pan Range: Off/-3dB centre/off
Balance Range: ± 6dB
   

Common Mode Rejection Ratio

Mic Input: >60dB typically
   

Digital I/O

Sync Input Sample Rate Range: 32kHz – 96kHz
Output Sample Rates: 32kHz, 44.1kHz, 48kHz, & 96kHz (Using Onboard Clock)
Output Sample Width: 24 bit
   

Output

Headphone Output Load: >45 ohms, recommended 400
Maximum Output (Analogue): +26dBu balanced into 2k or greater
   

Rear Panel Switches

Phantom Power: +48V individual per mic input
Gain Switch: +10dB per XLR balanced mono & stereo input & EXT 1, EXT 2 inputs
   

Input & Output Connections

Analogue Inputs: 5 x Microphone XLR 3 pin sockets
2 x Mono line XLR 3 pin sockets
2 x Mono/stereo line combi XLR 3 pin sockets & 6.35mm stereo jack sockets
1 x Telco XLR 3 pin socket
5 x Stereo line pairs XLR 3 pin sockets
2 x Stere line pairs phono sockets
1 x Stereo cleanfeed pair XLR 3 pin sockets
1 x Stereo insert, 3.5mm jack socket
Digital Inputs: 2 x S/PDIF phono sockets,
2 x TOSLink optical connectors
Analogue Outputs:
PGM:
AUX:
TELCO:
STEREO CLEANFEED:

2 x XLR 3 pin plug (balanced)
9-way ‘D’-type socket (balanced)
XLR 3 pin plug (balanced)
2 x XLR 3 pin plug (balanced)
Monitor Outputs: 6.35mm stereo jack sockets (2 x Presenter, 1 x Guest, 1 x Monitor)
Digital Outputs: AES/EBU XLR 3 pin plug (balanced) or S/PDIF phono socket.
Digital Sync Inputs: Wordclock on BNC, AES/EBU on XLR socket and S/PDIF on phono socket.
EXT Inputs: 9-way ‘D’-type socket
Mono Remotes: 25-way ‘D’-type plug
Stereo Remotes: 25-way ‘D’-type plug
Meterbridge Port: 15-way ‘D’-type socket
Talkback Interface: 9-way ‘D’-type socket
RS232 Serial Port: 9-way ‘D’-type socket
Mains Input: Filtered IEC, continuously rated 85-264VAC, 47-63Hz, 45w nominal, 50w peak
Fuse Rating: Anti-surge fuse 2A 20 x 5mm
   

Equipment Type

S1: S1 radio broadcast mixer
   

Physical Specification

Dimensions (Raw): 44.5cm (W) x 40.0cm (D) x 15.6cm (H)
17.5” (W) x 15.75” (D) x 6.1” (H)
Cut-Out Dimensions: 44.0cm, 17.3” (W) x 38.1cm, 15” (D)
both dims +0.2cm, -0cm